Intended Use; Delivery Content; Safety Instructions - VOLTCRAFT VGA LF Bedienungsanleitung

OPERATING INSTRUCTIONS
BS-9.8MM/20M VGA LF FLEX CAMERA
ITEM NO.: 1209064

INTENDED USE

This product is a camera attachment for endoscopes that can be used for optical
troubleshooting or inspection at facilities and installations that do not carry a live voltage.
These endoscopes are not included in the package contents of this product (see "Technical
data" section). The product is especially suitable for inspecting piping.
The reel included ensures that the camera and camera neck can be stored safely. The flexible
camera neck allows the camera on top to access inaccessible positions. The four LEDs built
into the camera head enable recording in completely dark areas. The brightness can be
controlled via the connected endoscope. The waterproof camera neck and camera head are
designed for contact with liquids (no acids or alkaline solutions, however). It is forbidden to
use the product on people and animals, in potentially explosive environments and in areas
carrying a live voltage. Power is supplied via the connected endoscope.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If
you use the product for purposes other than those described above, the product may be
damaged. In addition, improper use can cause hazards such as short circuiting, fire, electric
shock etc. Read the instructions carefully and keep them. Make this product available to third
parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.

DELIVERY CONTENT

• Flex camera (20 m)
• Extension cable (2 m)
• 2 x guide caps (Ø 1.5 cm, Ø 2.5 cm)
• Operating instructions

SAFETY INSTRUCTIONS

Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
VERSION 09/14
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• The endoscope must not be used in potentially explosive areas, areas carrying a
live voltage or for inspecting people and animals.
• Always roll the camera neck onto the reel when it is not in use.
• Avoid strong vibrations. The bending radius must not be less than the minimum
of 45 mm.
• The reel is not waterproof and therefore cannot be inserted under water. Protect
this part of the product against splashing water.
• The product may only be used for inspecting facilities that do not carry a live
voltage. The camera head and the guide cap are made of metal. This can lead
to short circuits during use. For safety reasons, disconnect all parts of the facility
from the power supply before each inspection.
• Only hold the camera head and camera neck in liquids that do not carry a live
voltage.
• The connection sockets must not come into contact with liquids.
• Always use the camera with a guide cap.
• Do not look directly into the LED light! Do not look into the beam directly or with
optical instruments!
• In industrial facilities, the accident prevention regulations for electrical equipment
and facilities issued by the Industrial Employers' Liability Association must be
adhered to!
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
If you are not sure about the correct connection or use, or if questions arise which are not
covered by these operating instructions, please do not hesitate to contact our technical
support or another qualified specialist.