Wire Spool Fitment - Holzmann MISA160 Originalbetriebsanleitung

ASSEMBLY

11.7.4 Wire Spool Fitment

1. Wire reel retainer Push and twist in, to retain wire roll adaptor onto wire reel
2. Roller tensioner Do not over tighten wire feed pressure roller as this can cause prema-
ture motor and roller failure. Correct way to adjust tensioner is to slacken off pressure so
that MIG welding wire does not feed, slowly adjust pressure until wire feeds smoothly, you
should be able to stop wire feeding by holding wire and it should slip on rollers. If you
have too little pressure wire will slip when welding causing unwanted Burnback into tips
3. Wire Feed Drive Assembly Make sure rollers are correct size for wire diameter selected,
to change roller size release retaining screw, remove roller turn roller around and slide on-
to shaft making sure the right size groove is in line with wire and refit retaining screw. The
INV160 comes fitted with a dual roller 0.6mm and 0.8mm
4. Wire reel adaptor Remove the wire reel retainer and wire reel adaptor, slide on roll of
wire and refit the reel adaptor.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 36
MIG/MAG Inverter Schweißanlage / MIG/MAG inverter welding unit MISA160