Controls And Settings - Holzmann MISA160 Originalbetriebsanleitung

ASSEMBLY

11.7.3 Controls and Settings

1. Welding Voltage This adjusts the welding voltage (weld power) from 0 to 10. Adjust
knob for power output required by job, preset welding voltage is shown in LED (Fig3.4)
2. Wire Speed This adjusts the wire feed speed from 0-100% Adjust the wire speed to suit
welding voltage (Fig3.1) and job requirements When adjusting the wire feed speed a value
is shown in the amperage LED (Fig3.5) This feature allows you to record this value along
with the preset welding voltage for easy setup to specific job when several different weld-
ing jobs are being done
3. Arc Force Gives further adjustment on weld characteristics, on traditional transformer
machines this was known as choke. Lower setting = softer weld with less splatter and less
penetration – for thinner materials Higher setting = harsher weld with more splatter and
penetration – for thicker materials
4. Voltage LED Display This shows the preset welding voltage when no welding is being
carried out When welding this shows the actual welding voltage This allows the machine to
be calibrated to BS if required by your company
5. Amperage LED Display This shows the preset wire feed speed when no welding is being
carried out When welding this shows the actual welding amperage This allows the machine
to be calibrated to BS if required by your company. When the function is in MMA, it shows
the preset is welding amps.
6. Warning LED This warning light will come on under these situations: Duty cycle of ma-
chine has been exceeded, the machine will stop working and the fan will continue to run
until machine has cooled down. The light will go off and welding may be carried out again.
If duty cycle has not been exceeded the warning light comes on to warn of either low input
voltage has been sensed or there is an internal fault with machine
7. Power LED This lights when machine is switched on
8. Switch MIG/MMA.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 35
MIG/MAG Inverter Schweißanlage / MIG/MAG inverter welding unit MISA160