Werbung
Function and Setting
Dip Switch
#1
Sound-to-light
OFF
Auto Beam
ON
DMX/Slave
ON
mode
As the above chart, DIP switch setting reference as follows:
Stand alone
(1). Sound active: ALL OFF
(2). Auto beam run: #1 ON
Master and Slave mode
(1). DMX and DMX Slave & Master: #1 and #10 ON
(2). All slave units put #2 ON, when master unit puts #1 ON, then all the units run under auto mode; when
master unit puts ALL OFF, then all the units run under sound active mode.
Universal DMX Operation (DMX mode)
This mode allows you to use universal DMX-512 console to operate.
1. Install the units in a suitable position.
2. Use standard XLR cable to connect your units together via the XLR connector on the rear of the units. For longer
cable we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using dipswitches.
4. Turn on all units. Use DMX console to control your units.
DMX Signal
#2
#3
#4
#5
OFF
OFF
OFF
#6
#7
#8
#9
7
#10
ON
Werbung
