Topcom clip phone 100 Bedienungsanleitung Seite 11

Clip Phone 100
3.4.3 Dialling memory numbers
Pick up the receiver and press M1, M2 or M3; or press the Memo button first, followed
by the memory location 0..9. The programmd number will be called automatically.
4 OPERATION CALLER ID (CLIP)
4.1 Setting the clock
• Press the Mode button to go through the different possibilities.
• Press the Set button when "SET TIME" appears on the display.
• Press the or buttons to set the month.
• Press the Set button to confirm.
• Repeat steps 3 and 4 to set the day and the hour.
4.2 Setting a language
This phone can show the display texts in several languages.
To set the desired language, take the following steps:
• Press the Mode button to go through the different possibilities.
• Press the Set button to confirm your choice.
4.3 Setting LCD contrast
You can change the LCD contrast of this phone :
• Press the Mode button until "SET CONTRAST" appears on the display.
• Press the Set button.
• Press the or buttons to set the desired contrast.
• Press the Set button to confirm.
4.4 Receiving and saving calls
The Clip Phone 100 receives a call and shows the information sent by the local
telephone provider. This information can consist of the caller's telephone number, the
date and the time; or the caller's name, his telephone number, the date and the time.
The phone can save 20 to 50 calls which can be reviewed later.
18
Clip Phone 100
It never saves the same call twice. When the memory is full, the old calls will be
replaced by the new ones in the memory.
4.5 Message indications
The following special messages show the status of the phone :
NO CALLS There are no calls in the memory.
LOW BATTERY The battery is almost empty.
OUT OF AREA The received call doesn't have the clip service or their service
is not connected to your clip service.
PRIVATE CALL The caller has a private number and therefore the information
is not visible on the display.
LINE ERROR The clip information was interrupted during transmission of
the data.
END OF LIST There are no more calls.
NO DATA SENT The number of the caller was interrupted during transmission.
R # Number of the same calls that came in.
4.6 Erasing and checking calls
4.6.1 Erasing
• Press the Delete button twice to erase the number on the display.
• Press and hold the Erase button for 6 seconds and all calls will be erased.
Display : NO CALLS.
4.6.2 Checking
• Press the the button to go to the next call. When you have gone through all calls,
'END OF LIST' appears on the display.
• Press the button to look at the previous call.
4.7 Setting the area code
If you do not want the area code to appear on the display every time a new call comes
in, you can program this in the memory.
19