Operation Telephone - Topcom clip phone 100 Bedienungsanleitung

Clip Phone 100
1 INSTALLATION
You can use batteries or an AC adaptor to activate the display of the telephone. When
you install the batteries, the telephone lines at the back of the phone have to be
disconnected.
To insert the batteries, take the following steps:
• Use a screwdriver or any other flat tool to open the battery compartment.
• Put three 1,5V (AA) batteries inside the battery compartment.
• Close the battery compartment carefully.
To install the phone, you have to do the following :
• Connect one end of the telephone cable to the back of the Clip Phone 100 and the
other end to the receiver.
• Connect one end of the telephone line to the back of the phone and the other end
to the telephone line wall socket.
2 BUTTONS
1 Numerical buttons
2 Ring volume control
3 Memory button
4 Memo button
5 Flash button
6 Mute button
7 Volume control
8 Pause button
9 Redial button
10 Direct Memory button M1
11 Direct Memory button M2
12 Direct Memory button M3
13 Erase button
14 Set button
15 Recall button
16 Mode button
16
Clip Phone 100

3 OPERATION TELEPHONE

3.1 Ring volume control
The ring volume switch is located on the base station. U can choose either HI, LOW or
OFF. Put the volume switch on HI or LOW. When you choose OFF, the phone does not
ring when a call comes in.
3.2 Flash
Press the Flash button to activate certain services as Call Waiting or to transfer phone
calls, if this service is provided by your telephone provider.
3.3 Last number redial
Press the Redial button and the last dialled telephone number will be redialled
automatically.
3.4 Memory numbers
You can program 16 telephone numbers in the memory under the memory locations
0..9 (numerical buttons) or M1, M2 and M3.
3.4.1 Programming memory numbers
• Pick up the receiver.
• Press the Memory button.
• Enter the telephone number.
• Press the Memory button again.
• Press the memory location 0..9 (numerical buttons) or M1, M2, M3.
• Put the receiver back on the phone.
3.4.2 Checking memory numbers
• Press the Memo button and the memory location 0..9 or press M1, M2 or M3.
• The programmed number appears on the display.
17