Tenovis cs 578 Bedienungsanleitung Seite 43

Changing basic settings on the base station
Block
programming
of all parameters
for the dialling
method
Notes:
Setting signal
key "R"
Notes:
Setting base
station settings to
their initial state
(Reset)
Notes:
Scroll to menu item 35
"Block programming"
Block 1
(Priv. PABX)
Dialling method: DTMF
Dial pause after
exchange code: 0 s
signal key: 80 ms
(short flash)
S Standard- and delivery state is Block 1.
Scroll to menu item 36
"Signal key"
DTMF: 0: no function
1: Flash short (80 ms), for functions in a
2: Flash long (250 ms), for using
Pulse-dialling (PD): 0: no function
S The flash function may only be set in the DTMF dialling
method.
Scroll to menu item 38
"Reset base"
S The following are reset: Dialling method: DTMF, base station
bell volume: 2, set up dialling bars, call assignment hunt group,
exchange code none, dial pause none, signal key flash short,
block programming 1.
S The following are not reset: Log in mobile units, base-PIN, call
charge factor and total, base bell melody.
1
. . .
Enter the digit for the desired
block
Block 2
(Main line 1)
PD
none
no function
0
. . .
Enter the desired setting
telephone system
network provider service features
C
Press the "Clear" key until
the acknowledgement
tone sounds.
continued
3
Block 3
(Main line 2)
DTMF
none
250 ms
(long flash)
2
43