Battery Recharge And Replacement; Advanced Operations; Handset Registration - Engenius EP802 Handbuch

then, within 2 seconds, press the digit "＊" to unlock.
3. Once returning back to standby mode for 15 seconds,
the keyguard will be automatically enabled.
4. Key Guard is in effect until unlocked.

Battery Recharge and Replacement

1. Charge the battery when one or several of the following happen:
a. Phone beeps twice (every 60 seconds in talk mode, every 10
minutes in standby mode).
b. Battery icon is empty.
c. Phone does not respond when a power on/off key
d. LCD and backlighting become dim.
e. Talk range shortfall is experienced.
2. You can replace the handset battery after placing the call-in-progress on
hold and press key. To retrieve the call on held, press talk key again
after replaced battery and power the handset on..
3. Battery talk time and standby time vary depending on the talk/standby
pattern and the operating distance. Putting the handset back to charger
cradle as often as possible is recommended for best performance. Use
only manufacturer provided battery and charger!
is pressed.
~35~

Advanced Operations

Handset Registration

1. If your handset(s) is purchased as part of a system, it has been pre-
registered with the base station at the factory.
2. If Handset ID as "00," that means it is a new handset or the ID has been
erased. You need to register the handset with the base station.
3. Registration:
a. Press MENU-7 to enter the registration mode
b. Press and hold the base's PAGE button for 3
seconds until the In Use LED (white color) lighting
up and flashing, also the base station will emit
prompt sound to remind you the base station is in
the registration mode..
c. Press handset key "1", this completes the
registration process. The base station will assign a
handset ID between 12 and 19 automatically. The
assigned ID will be displayed on the handset LCD,
indicating successful registration.
d. Repeat above steps for all additional handsets.
4. De-registration:
a. You can de-register the handset you're using from
the base station. De-registration will reset the
Handset ID to 00, erase the system security code,
and free up the handset ID for future registration.
b. After deregistration, the handset will not be able to
use the base station to make or receive phone
calls, nor can it intercom other handsets.
c. Press MENU-7 to enter the registration mode
d. Press and hold the base's PAGE button for 3
seconds until the In Use LED (white color) lighting
up and flashing, also the base station will emit
prompt sound to remind you the base station is in
the de-registration mode.
e. Press the handset number key "2", this completes
the de-registration process. Upon successful de-
~36~