Base Illustration; Base Features; Basic Base Station Features; Reset Button - Engenius EP802 Handbuch

Base Illustration

Page / Registration
Base unit Diagram
DC Jack Phone Jack

Reset Button

Power LED: blue color
In use LED: white color
Line Jack
~21~

Base Features

Basic Base Station Features

1. Antenna
a. The antenna port has a
antenna or cable, turn counterclockwise; to install, turn
clockwise. Improper installation may damage the connector.
b. When using an outdoor antenna, locate the antenna (not the
base station itself) as high as possible for a clear transmission
path.
2. LED
a. Power (bue color): it indicates base station has power.
b. In-Use (white color): it indicates an active telephone line.
3. RESET Button
a. Restores base station to factory settings
b. Reset button is intended to prevent accidental system reset.
c. All handsets (including administrator) and additional base(s)
need to be re-registered after a base station reset.
4. Page Button (PAGE)
To search a misplaced handset; press "PAGE" button, all registered handsets
beep for 30 seconds.
Press "PAGE" again or any key on handset to stop.
5. Registration Button (PAGE)
Enters registration mode along with handset, assigns handset ID (11-19).
6. Line Jack
Standard RJ-11C/CA-11A connector to plug in the telephone line
7. Telephone Jack
Another RJ-11C to plug in the optional answering machine
8. DC In: to plug in the power adaptor
normal thread connector
; to remove
~22~