Dialling Mode (Tone/Pulse) Setting - Geemarc CL210A Handbuch

SETTINGS
Switch at Position
The additional amplification and tone controls are turned off each time you
use the telephone. The LED light on the amplify will be off.
Pressing the Amplify button once during a call will enable tone control and
additional amplification. The LED light on the amplify will turn on to reflect
this change. If you press the amplify button once more, the additional
amplification and tone control features will be turned off once again. The
LED light will turn off to reflect this change.
Irrespective of how many times you press the amplify key throughout a
call, the next time you pick up the handset, these functions will be turned
off once again.
Tone Receiving Adjustment
If the receiver volume has been amplified, the tone control can also be
adjusted. You can adjust and increase the low frequency or high
frequency sounds with the tone slide control on the front edge of the unit.
Note: The tone adjustment function will not be effective when the receiver
volume is set to normal level.

Dialling Mode (Tone/Pulse) Setting

The Tone/Pulse switch is factory pre-set to Tone position (T). In the UK,
all telephone exchanges now use Tone dialing. If your telephone does not
dial out, it is probably being used from an older private switch- board
(PBX). In this case, the Tone/Pulse switch (at rear of the unit) must be
moved to Pulse.
10