Introduction / Scope Of Supply; Operator's Safety - Unitest Testfix Bedienungsanleitung

Conformity Symbol, confirms respect of valid
EMV Directive (89/336/EEC). The standards EN
50081-1: 1992 and EN 50082-1: 1992 are re-
spected.
The Low Voiltage Directive (73/23/EEC) is not ap-
propriate for voltages exceeding 50 V AC/75 V DC.
Scope of Supply
1 pc UNITEST TESTFIX /
UNITEST TESTFIX electronic
1 pc instruction manual
2 pc clamp uninsulated
The batteries are not included in the scope of supply.

2.0 Operator's Safety

The Continuity and Line Tester TESTFIX and TEST-
FIX electronic have been designed and tested in
compliance with Safety Regulations for electronic
test instruments and are supplied in safe and per-
fect condition.
To maintain this condition, the operator must re-
spect the safety references contained in this in-
struction manual.
The instruction manual contains information
and references required for safe instrument
operation.
Read this instruction manual thoroughly and re-
spect all points before using the instrument.
Failure to understand this instruction manual and to
comply with the warnings and references can result
in serious or hazarous injuries or instrument dama-
ge.
The UUT must be voltage-free. Verify this condi-
tion, if unsure, by using a voltage tester equip-
ped with a display.
Both TESTFIX and TESTFIX electronic are not
appropriate for use in live circuits!
Prior to any measurement, ensure that test le-
ads and test instruments are in perfect condi-
tion.
Operator's Safety
13