Transmitting A Test Signal To The Cable Tracing - VOLTCRAFT LSG-3 Bedienungsanleitung

Transmitting a test signal to the cable tracing

The net toner represents in connection with the net probe an effi-
cient cable tracing and lead identification system. The net toner
works as a signal transmitter and the net probe as a signal receiver.
Make sure before connection that the cables are not live
(danger to life).
• Turn the switch-over for testing mode (22) to the central position
"OFF".
• The signal is emitted during testing on all connections and jacks
(23/24/25). Make the corresponding connection.
To strengthen the test signal on the cables, connect the
black crocodile terminal to the earth of the cable to be
tested.
• the test adapter (15) can be used to test the co-axial systems (F-
plug norm). - Insert this into the test jack (23).
• Turn the switch-over (22) to the right in the position "TONE".
• The signal frequency can be switched over using the pushbutton
(18) (Hi/Lo).
• The display LEDs (21) light up weakly orange.
• For identification, follow the instruction in the next section of the
net probe
• Turn the switch-over (22) after the end of the test to the central
position "OFF" again.
33