Explanation Of Symbols; Inserting/Changing The Batteries - VOLTCRAFT VC-56 Bedienungsanleitung

Explanations of Symbols
The voltage tester shows the following symbols:
DC DC voltage
AC AC voltage
- DC voltage negative potential (DC)
Phase display from 100 to 690V ~ 50/60Hz
when used as a „single-pole" phase tester.
Continuity test symbol
Rotating field display clockwise
Rotating field display anticlockwise
Device for work to be performed with voltage
present
Battery replacement symbol
BAT

Inserting/Changing the Batteries

The voltage tester is operated with two micro-batteries
(type AAA, in the scope of delivery).
Proceed as follows to insert or change the batteries:
• Loosen the screw on the battery compart-
ment lid (5) with a suitable screwdriver
and remove it.
• Insert two micro-batteries (AAA) into the
battery compartment. Observe the pola-
rity information in the battery compart-
ment. If possible, use alkaline batteries.
They guarantee a longer service life.
• Then, carefully close and screw down the battery
compartment lid again.
The batteries need to be changed if the „Low Bat" ( I )
symbol lights up on the LCD display or when the LCD
display stays dark after contacting both test tips.
The VC-56 will show no reading if the
batteries are flat. The device must not be
operated with flat batteries or without
batteries.
To prevent damage to the device from leaking batteries,
remove the batteries from the device if you will not be
using it for a longer period.
For the same reason, we recommend that you remove
flat batteries immediately.
18