Cable Test For Analogue Telephone Cables - VOLTCRAFT LSG-3 Bedienungsanleitung

To trace the signal, proceed as follows.
• Slide the mode switch (14) on the side to the "TRACE" position
for signal tracing.
• Press the test key (9) and the net probe will be activated. Hold this
pressed down during the cable tracing.
• Signalisation takes place optically over the signal display (11) and
acoustically over the loudspeaker (8)
• Now set the desired signal volume on the volume control (10).
• Guide the test tip (2) beginning with the signal transmitter (16)
parallel to the course of the cable. The volume must remain con-
stant if the cable tracing is correct
• If you wish to identify a certain cable end, you can select from
three test possibilities.
1. Search without contact with the test tip (2)
2. Contact-search through the RJ45 jack (4) at the side
3. Contact-search through contacts (6) at the back

Cable test for analogue telephone cables

Analogue telephone cables can also be checked for their condition
on the net probe.
The status is displayed over two light diodes.
Do not use the net probe on cables on which voltages
greater than 24V AC / 48 VDC are or could be existent
(danger to life!). Make sure of this before commencing
the test.
35