Starting Operation; Inserting/Replacing Batteries - VOLTCRAFT LSG-3 Bedienungsanleitung

Starting operation

Before starting up operation, both the intended pur-
pose of use and the safety instructions and techni-
cal data are to be observed!
Make sure before starting up operation that the
device is suitable for the purpose of use for which it
is to be used.

Inserting/replacing batteries

A 9-V compound battery is required for operation (not included in
the scope of delivery).
Open the battery compartments (7 and 19) on the back of the two
devices, connect the battery clip paying attention to the polarity of
the battery and close the compartment again with care.
Replace the battery if, after some period of operation, the undervolt-
age LEDs (LOW BATT 13/17) appear. To do this, proceed as follows:
disconnect the corresponding devices from all connected cables.
open the battery compartment (7/9).
remove the flat batteries and insert an unused battery of the same
type paying attention to the polarity.
Use only alkaline 9-V compound batteries. These are
more efficient and afford a longer operating period than
the conventional zinc-carbon batteries.
Close the battery compartment lid after inserting the battery correctly.
Incorrect polarity of the battery will lead inevitably to
destruction of the device!
28