R&S ESCI Bedienungsanleitung Seite 731

R&S ESCI
Gerät Befehl (Sheet 32 of 50)
FSET [SENSe<1|2>:]AM:RANGe[:UPPer]
FSE [SENSe<1|2>:]AVERage:AUTO
R&S FSE [SENSe<1|2>:]AVERage:COUNt
ESCI
FSE [SENSe<1|2>:]AVERage:COUNt
R&S [SENSe<1|2>:]AVERage:TYPE
ESCI
FSE [SENSe<1|2>:]AVERage:TYPE
R&S FSE [SENSe<1|2>:]AVERage[:STATe<1...3>]
ESCI
FSE [SENSe<1|2>:]BANDwidth|BWIDth:DEMod
FSE [SENSe<1|2>:]BANDwidth|BWIDth:PLL
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo
ESCI
FSET [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:AUTO
ESCI
FSET [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:
EXTernal[:STATe]
R&S [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RATio
ESCI
FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RATio
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]
ESCI
FSET [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]
Operating Manual 1166.6256.11 - 02
Unterschiede R&S FSP/R&S FSE-Familie
Parameter Hinweise
3PCT | 10 PCT | 100PCT not available for
R&S ESCI
ON | OFF not available for
R&S ESCI
0 to 32767
0 to 32767
VIDeo | LINear command is used to
select logarithmic or
linear averaging on the
R&S ESCI;
therefore parameters are
incompatible to the
R&S FSE
MAXimum | MINimum | command is used to
SCALar select logarithmic or
linear averaging on the
R&S ESCI;
therefore parameters are
incompatible to the
R&S FSE
ON | OFF
<numeric_value> not available for
R&S ESCI and
R&S FSET
AUTO | HIGH | MEDium not available for
| LOW R&S ESCI
1Hz to 10MHz R&S ESCI
1Hz to 500MHz
ON | OFF
ON | OFF not available for
R&S ESCI
0.0001 to 1 only numeric values
available. Parameter
ranges differ between
R&S ESCI and
R&S FSE
0.001 to 1000 | SINe | also text parameters are
PULSe | NOISe available. Parameter
ranges differ between
R&S ESCI and
R&S FSE
not available for
R&S FSET
10Hz to 10MHz (anal. R&S FSE: 10Hz to
filter) 1Hz to 10MHz 10MHz (models 20) 1Hz
(FFT filter) to 10MHz (models 30)
10 Hz to 500MHz
6.329