Dell 3400MP Betriebsanleitung Seite 25

(continued)
Problem
The image is stretched when
displaying a 16:9 DVD
Image is reversed
Lamp is burned out or makes
a popping sound
LAMP light is solid orange
LAMP light is blinking
orange
TEMP light is solid orange
TEMP light is blinking
orange
The remote control is not
operating smoothly or in very
limited range
Possible Solution
The projector automatically detects a 16:9
DVD and adjusts the aspect ratio to full
screen with a 4:3 (letter-box) default setting.
If the image is still stretched, adjust the aspect
ratio as follows:
• If you are playing a 16:9 DVD, select 4:3
aspect ratio type on your DVD player (if
capable).
• If you cannot select 4:3 aspect ratio type on
your DVD player, select 4:3 aspect ratio in
the Image Settings menu in the OSD.
Select Management from the OSD and adjust
the projection mode.
When the lamp reaches its end of life, it may
burn out and may make a loud popping sound.
If this occurs, the projector does not turn back
on. To replace the lamp, see "Changing the
Lamp" on page 26.
If LAMP light is solid orange, replace the
lamp.
If the LAMP light is blinking orange, the lamp
cover is not closed properly. Close the lamp
cover properly. If the problem persists, contact
Dell.
The projector has overheated. The display
automatically shuts down. Turn the display on
again after the projector cools down. If the
problem persists, contact Dell.
A projector fan has failed and the projector
will automatically shut down. If the problem
persists, contact Dell.
The battery may be low. Check if the laser
beam transmitted from the remote is too dim.
If so, replace with 2 new AA batteries.
Troubleshooting Your Projector
(continued)
25