SELFSAT SNIPE DOME Air Bedienungsanleitung Seite 23

13
Equipment to initiate Cable holder installation.
15
Arrange cable holder in front of (30cm apart
from) antenna center by facing open side of
cable holder toward projected part of the
mounting plate. Then attach friction tape
outside of cable holder.
17
Insert Receiver & controller cable through the
hole.
19
Apply silicone around the cable holder.
22
14
Put the cable inside the Cable holder as above
picture.
16
Make 15mm drill hole in the center of the tape
marking.
18
Place cable holder in the tape marked and make
3 of 2mm drill holes.
20
Fix cable holder on the car roof with 3 of M4x20
screws.