Heraeus Baureihe 6000 Betriebsanleitung Seite 46

Electronic
temperature
controller "Digicon"
Digicon S
with interface
Operation with
external program
Measurement of the
actual temperature
n n n
u u u
electronic controller
w. digital temp, display
for temp, range:
20 - 300 °C
Setting:
The electronic controller features digital display of the set
and actual temperature.
Press the control button and select the desired working
temperature. The set value appears in the digital display.
When the control button is released, the actual value
appears.
The LED (top left) indicates that the heating system is on.
The "Digicon S" temperature controller controls the
temperature of the heating oven in accordance with the
setpoint. The actual temperature is indicated digitally.
When the setpoint button (blue) is pressed, the desired
temperature replaces the actual value in the display.
The interface module is located above the "Digicon S"
temperature controller (in models T/UT 6030, 6420 and
6760 it is next to it).
Connect connecting cable (diode plug) to socket
"W
e x t
(0..20mA)".
0mA = 0°C 20 mA = 300°C
Admissible load Rj = 500 Q
This connection converts from the internal to the external
setpoint program. There must be a bridge between pins 3
and 4 in the diode plug.
The actual temperature can be measured at
the two " X
e x t
" sockets as voltage of 0-10V.
0Volt = 0°C 10Volt = 300°C
Admissible internal resistance R; = 1 kilo Q
View of module
with pin assignment
!
~>
3
4
5
3
n
+ 0 .
- g .
, 0 ,
- a .
. .20
. .20
. . 10
. . !Q
V
V
WPPAP1/ID 368
50012336
- 1 2 -