Installing The Battery - AIPTEK dv t200 Handbuch

Installing the battery

1
Open the battery
compartment cover.
Slide the battery compartment
cover open as indicated.
2
Install the battery.
Place the accessory Li-Ion battery
into the compartment. Note that
the metallic contacts must be
aligned with the contacts in the
compartment.
3
Replace the cover.
After the battery is properly
installed, replace the battery
compartment cover.
Treat the Li-Ion battery with care:
• Keep the battery away from fire or high-temperature environment
(over 140ºF or 60ºC).
• Do not drop the battery or try to disassemble it.
• If the battery is not used for long periods, fully discharge and
charge the battery at least once a year to maintain its lifecycle.
Upon using the battery for the first time, you are recommended to
fully discharge and then charge the battery to ensure its lifecycle.
Purchasing additional batteries:
This camera uses one NP-60 Li-Ion battery as power source. You
can purchase the NP-60 Li-Ion Rechargeable battery (3.7 volt;
850mAh ~ 1000mAh) at your local shop.
5