Causes Of Errors And Error Rectification - Hama 118569 Bedienungsanleitung

Causes of errors and error rectification

The following table can be used to localise and rectify minor errors with the device:
GB
21
Error Possible cause
Device is switched off
Power supply adapter not
connected correctly
Display is blank
No mains power
Device is faulty
By static electricity, such as
occur during normal daily
use (carpet, wool sweater),
Device turns off
it may happen that the
device will go into Standby
Mode.
No storage medium is
inserted
No image
appears
The storage medium does
not contain data
The outdoor sensor
The inserted batteries have
displays no data
little or no charge
Data from the
outdoor sensor is
Your outdoor temperature
displayed only occa-
sensor is too far away from
sionally
the weather station
No weather data is
The temperature sensor
displayed
and the digital picture
frame are not in contact
with one another
Solution
Switch on the device.
Ensure that the power supply
adapter is plugged in and
connected to the device.
Check your fuse box.
Inform our customer service
department.
In case that the device shouldn´t
react on any commands or show
a black screen, reset the device by
pressing the POWER button on the
remote control or on the backpanel
of the device.
Insert a storage medium.
Check your storage medium.
Test or change the batteries
in the outdoor temperature
sensor and reconnect the two
units
Position your outdoor sensor
closer to the weather station
and reconnect the two units.
Make sure that the plug
contact of the indoor sensor is
connected firmly and correctly
with the digital picture frame.
If necessary, disconnect the
device from the mains, recon-
nect the indoor sensor to the
picture frame, and switch the
device on again.