Channel Selection - Medion MD 24019 Bedienungsanleitung

Channel selection

The receiver keeps an internal channel list in its memory. This list contains all channels of
the activated satellites. If you have deactivated some satellites the channels that belong to
these satellites will not be visible in the list. There are several methods of choosing a TV
channel:
P+ / P– Change to the previous or next channel in the channel list
TV / RADIO Change to TV or radio mode
SWAP Change back and forth between actual and previously viewed channel.
The operating software of the receiver only notes the last channel that
was active at least one second. This means that you can change
channels quickly using the P+/P– button and these channels will be
ignored by the SWAP function.
0 – 9 You can always enter a channel number using the number buttons
directly. The entry can be shortened using the OK button (e.g. when
you wish to enter a single figure channel number) or EXIT to cancel.
To shorten the process of entering a figure, which is less then four
digits, keep the button pressed when entering the last number.
Note: You can call up deactivated TV channels by entering the channel
number directly.
MD 24019 63