Regulatory Information - Toshiba SHX10 Bedienungsanleitung

To turn on the projector
1.
Use the bundled AC power cord to plug the
projector into a power outlet.
Plugging into a power outlet causes the three
indicators on the top of the projector to light
amber. After a short while, two of the indicators
will go out and only the POWER/STANDBY
indicator will remain lit amber, which indicates the
standby state.
Note that the projector will not turn on if you press
the [P] (Power) key while all three indicators are
lit amber. Wait until the projector is in the standby
state before trying to turn it on.
NOTE
This product is also designed for IT power distribution system with phase-to-phase voltage 230V.
2.
Turn on the computer or video device that is connected to the projector.
3.
If the projector lens cover is covering the lens, remove it.
4.
Press the [P] (Power) key.
This causes the POWER/STANDBY indicator to flash green.
Within a few seconds, POWER/STANDBY indicator stops flashing and remains lit green, and the
projector starts projecting an image from the device connected to it.
A "Language" window will be projected the first time you turn on the projector. Use the procedure
under "Specifying the Display Message Language" on the page EN-17 to configure the language
settings.
NOTE
If the Eco Mode is turned on, the LIGHT indicator will light green when the projector is turned on.

REGULATORY INFORMATION

CE compliance
This product is CE marked in accordance with the requirements of the applicable EU Directives.
Responsible for CE marking is Toshiba Europe GmbH, Hammfelddamm 8,41460 Neuss, Germany. A
copy of the official Declaration of Conformity can be obtained from following website:
http://epps.toshiba-teg.com.
Laser Precautions
This projector is a Class 1 laser device that conforms with IEC 60825-1.
This projector has a built-in laser module.
Disassembly or modification is very dangerous and should never be attempted.
Any operation or adjustment not specifically instructed by the user's guide creates the risk of hazardous
laser radiation exposure.
REGULATORY INFORMATION
Bundled AC power cord
The shape of the plug
depends on your
geographical area.
EN-6
Power supply connector