Changing Tools - NovoPress HPA400 Betriebsanleitung

CAUTION
Insufficient crimping depth due to early release of the start button.
Therefore:
–
3. Press and hold the start button (1).
• Green LED (2) goes out.
• Red LED (3) lights up.
• Plunger extends.
4. The crimping sequence is completed when:
• Red LED (3) goes out.
• Green LED (2) lights up.
5. Release the start button (1).
6. Pull the return stroke button (5) until the plunger is in the desired position.
Pos : 52 /System/Wer kzeug wec hs el/H PA400 @ 2\mod_1469707153345_18.doc x @ 22031 @ 1 @ 1
9

Changing tools

CAUTION
Risk of injury from inadvertent starting the device
Therefore:
–
1. Withdraw the plunger thus far from the tool until the grub screw (7) can be accessed.
2. Remove the locking screw (11) from the upper tool (10).
3. Remove the upper tool section (10).
4. Remove the locking screw (7) from the lower tool (8).
5. Remove the lower tool section (8).
Information!
Faulty press fittings due to incorrectly inserted lower tools for hexagonal
crimpings (12)
Therefore:
–
6. Insert the new tools and tighten the screws.
Pos : 53 /RVT/Allgemeines /#### Seitenumbr uch #### @ 0\mod_1380200837280_0.doc x @ 885 @ @ 1
Hold the start button (1) down until the pressing operation is ended automatically.
Remove the battery before changing the tools.
12 13
9
10
11
The side with the centre hole (13) must always face the locking screws (7).
14
7
8
21
HPA400
EN