Denver CRL-310 Bedienungsanleitung Seite 7

2. The LED DISPLAY will show the radio frequency for about 5
seconds and then revert to normal time display.
AUTOMATIC SEARCH FOR RADIO STATIONS
To automatically search for stations with strong signals, press and
hold the main unit button (10) and (11) or the remote control button
(7) and (11) until the frequency readout on the display begins to
scan. Release the button. The tuner will stop on the first strong
station it finds.
MANUAL SEARCH FOR RADIO STATIONS
1. Tap the unit (10) and (11) button or the remote control button (7)
and (11) repeatedly to choose your desired radio station.
2. Tap the unit (12) and (13) button or the remote control button (9)
and (14) to set the desired volume level. The volume level
reading will appear in the LED DISPLAY.
Notes:
- Use manual tuning to select weaker stations that might be
skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency of
the station, for example, it stops on 88.9 MHz instead of 88.8
MHz, use the manual tuning method to "fine tune" to the exact
frequency of the desired station.
HINTS FOR BEST RECEPTION
FM - To insure maximum FM tuner reception, unwrap and fully
extend the EXTERNAL FM WIRE ANTENNA for best FM radio
reception.
TO SET/RECALL RADIO STATION PRESETS
1. Press the unit button (10) and (11) or the remote control button
(7) and (11) select the desired radio station.
2. Press and hold the unit (7) button or the remote control button
(12), the next available preset memory number will flash on
the LED display. (Note: "P01" will flash in the display if you are
programming presets for the first time.)
3. Press the unit button (10) and (11) or the remote control button
(7) and (11) to change to the desired preset number P01 thru
P10.
4. Repeat steps 1 thru 3 to preset up to10 FM stations.
5. To recall one of the preset stations already programmed, Press
ENG-6