Denver CRL-310 Bedienungsanleitung Seite 5

remote control button (7), (11) for faster scanning backward or
forward. Tap the unit button (7) or the remote control button (12)
to confirm.
4. Repeat steps #2 to #3 to adjust the month, day, time format,
current hour and finally current minute in the same way.
Notes:
- The display sequence in calendar / time set mode will be as
follows:
Year → Month → Date → 12/24 Hour Time Format → Real Time
Hour → Real Time Min → Normal Time
- To check the year while current time is displayed, tap the
unit button (10) or the remote control button (13) once. The LED
DISPLAY will change to year display for 5 seconds and then
revert to current time automatically.
- To check the date while current time is displayed, tap the
unit button (10) or the remote control button (13) twice. The LED
DISPLAY will change to date display for 5 seconds and then
revert to current time automatically.
- During the time set, if no button is being pressed within 10
seconds, the current display time will be automatically stored.
- Make sure the hour is set so that the PM indicator is displayed
correctly for afternoon/night times.
Switching the Unit On/Off
Press the unit on/off button (14) or the remote control on/off button
(1) to switch the unit on or off.
Volume Adjust
Press the unit (12) and (13) button or the remote control button (9)
and (14) button to set the desired volume level. The volume level
reading will appear in the LED DISPLAY.
Display Brightness (in standby)
In standby mode, Press the unit DIMMER button (8) or the remote
control DIMMER button (3) to adjust the display brightness.
ENG-4