Denver CRL-310 Bedienungsanleitung Seite 10

• NS (natural sound):
As soon as your set alarm time is shown, the natural sound switches
on. The natural sound is played. The volume increases slowly to the
set volume. The volume cannot be adjusted.
NOTE:
• The alarm function turns off automatically after 30 minutes until
the next day.
7a. If you want to be awakened by a radio station, select the
maximum alarm volume using the unit (10) and (11) buttons or
the remote control (7) and (11) buttons.
8. Press the unit Alarm 1 button (12) or the remote control Alarm 1
button (8) to confirm. Then select the light intensity (L) for the
alarm function. Selecting "OFF" will cancel this function.
NOTE:
The light inside the lamp shade (1) will turn on 30 minutes prior
to the pre-set alarm time. The brightness will gradually increase,
starting at the intensity level previously set.
9. Finally, press the button again. The first alarm time is now
activated.
To set the second alarm time, repeat the above steps with the
main unit Alarm 2 button (13) or the remote control Alarm 2
button (10).
NOTE:
• If the alarm time has been activated, AL1 or AL2 will appear in
the display.
• In order to briefly display the set alarm times, press the unit
Alarm 1 button (12) or the remote control Alarm 1 button (8),
respectively the unit Alarm 2 button (13) or the remote control
Alarm 2 button (10).
• Turning off the Alarm Press the unit on/off button (14) or the
remote control on/off button (1) to stop the alarm.
Deactivate the Alarm Function
1. Switch the device to standby with the unit button (14) or the
remote control button (1).
2. To deactivate the alarm function, press and hold the main unit
button (12) and (13) or the remote control button (8) and (10) for
about 3 seconds. AL1 or AL2 will disappear.
ENG-9