Alarm Function - AEG FU 4002 P Bedienungsanleitung

English
56

Alarm function

NOTE: Important!
The alarm time cannot be set, activated or deactivated whilst the unit is searching for a
radio signal.
Setting of the Alarm
You can set two alarm times. Proceed as follows:
1. Press the ALM SET button (3) for approximately 3 seconds. The display shows "AL1"
and the number of the actually set alarm time starts to flash.
2. Use the buttons UP (8) and DOWN (7) for setting.
3. Press the ALM SET button for confirmation. The minutes start to flash.
4. Use the buttons UP and DOWN for setting.
5. Press the ALM SET button to set the second alarm time. Proceed as described above
for the setting.
NOTE:
• If you want to set only the first alarm time, press the ALM SET button until the
time is displayed again.
• Press the ALM SET button to display the set alarm times for a short time.
Activate alarm times
You can activate the first or second alarm or both together.
1. When the time is displayed, briefly press the ALM SET button (3). The message "AL 1"
appears on the display in place of the seconds display.
2. Press the UP button (8) to activate the first alarm time. The " " symbol appears on the
display.
3. Press the ALM SET button again. The message "AL2" appears on the display.
4. Press the UP button to also activate the second alarm time. The " " symbol appears
on the display.
5. Press the ALM SET button again to return to the time display.
A beep will sound when the set alarm time is reached. The intensity of the beep increases
slowly.
NOTE:
If the alarm is not interrupted, the beep switches off by itself after two minutes.