Installing/Removing The Belt Clip; Charging The Battery Pack; Autonomy - Midland ALAN HP446 extra Bedienungsanleitung

INSTALLING/REMOVING THE BELT CLIP

1
1. Gently slide the clip from top to bottom into the appropriate guides locat-
ed on the back of the transceiver until it locks.
1
To remove the belt clip:
1. Press the small plastic lever located on the top of the belt clip.
2. Gently slide the belt clip towards the antenna until it comes away from the
transceiver.

Charging the battery pack

The new 1300 mA NiMh battery
pack will not hold a full charge.
It will need to be cycled at least 3
times. To cycle a battery it is neces-
sary to fully discharge it and then
charge it. Battery life may be
extended by cycling every month.
1. Connect the cable mounted jack
from the AC adaptor to the
2
socket located on the charger base.Plug the AC adaptor into an AC
power outlet.
2. Switch the transceiver off.
3. Insert the radio, with the keypad towards you, into the charger-base.
4. The status led of the charger turns red indicating that the charging
process is on.
5. Leave the radio in the charger until the battery is fully charged (this may
take up to 10 hours with the slow charger; to 2 hours with the rapid charg-
er).
Do not overcharge the battery.
If possible only charge the battery when it is fully discharged or has been
used for a considerable period of time, re-charging partially discharged
batteries will result in memory effect.
The charger of your ALAN HP 446 extrá allows also the charge of the
battery pack on its own.

Autonomy

Up to 26 hours with the standard duty cycle (10% conversation, 90%
standby). Such values have been obtained during testing. The effective
autonomy is influenced by : use of the radio, enabled functions such as
Time Out Timer. The power save function may be enabled by your system
administrator only.
blinking when the battery charge is low.
5
Setup