Further Tonearm Adjustments - THORENS TD 2015 Bedienungsanleitung

Further Tonearm Adjustments

The tonearm headshell allows an overhang adjustment
of ± 2,5 mm to be made. To adjust overhang, loosen the
screw holding the headshell and move the headshell as
required.
➔ Fig. 6
A screw at the rear of the tonearm allows a further over-
hang adjustment of ±3 mm as well as an azimuth ad-
justment of ±5°. The screw is recessed into the top of
the bearing housing and can be loosened with a 2-mm
hex key.
➔ Fig. 7
Fig. 6 Fig. 7
The vertical tracking angle (VTA) can be adjusted by
raising or lowering the tonearm. ➔ Page 34
Take care not to over-tighten the screws after making
adjustments.
31