Reloop JOCKEY IIIMaster Edition Bedienungsanleitung Seite 42

4. Now select the button „Add..." followed by „Import".
In the select screen open the mapping file that is found on the CD or that was downloaded from the
Reloop support site.
Troubleshooting
Should a problem arise and the Jockey 3's LEDs are not lit correctly, in most cases this is probably caused
by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, OSCulator, Bome Midi Translator etc.).
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the upper right corner.
2. Open the category „Controller Manager".
3. For the following device entries the following port assignments have to be configured:
Device
Jockey 3 V* (Deck A)
Jockey 3 V* (Deck B)
Jockey 3 V* (Deck C)
Jockey 3 V* (Deck D)
Jockey 3 V* (Mixer)
Jockey 3 V* (FX Presets)
42
In-Port
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Out-Port
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3
Reloop Jockey 3