Mounting The Rear Speakers - Yamaha NS-P220 Bedienungsanleitung

Mounting the rear speakers

1
Screw
(type B)
2
3
Mounting
bracket
(type B)
Mounting
bracket
(type B)
Tapping screw
(Available at the
hardware store)
Min.
20 mm
Mount the rear speakers on a shelf, rack or directly on the
floor, or hang them on the wall.
To mount the rear speakers on a wall by
using the provided mounting brackets
(type B)
Note
It is recommended that you connect the speaker cords to
the speaker's terminals before attaching the bracket to the
speaker.
1
Attach the bracket to the bottom of the speaker by using
the provided screw (type B).
2
Turn and/or slide the speaker on the bracket according
to your preference, and then, tighten the screw.
3
Fasten screws into a firm wall or wall support as shown
in the figure, and hang the holes of the mounting
bracket on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
Note
If desired, you can hang the speaker directly on the
protruding screws on the wall without using the bracket.
WARNING
● Each speaker weighs 0.7 kg (1 lbs. 9 oz.). Do not
mount them on thin plywood or a wall with soft
surface material. If mounted, the screws may come
out of the flimsy surface and the speakers may fall.
This damages the speakers or causes personal
injury.
● Do not install the speakers to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause them to fall.
● To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
● Select a proper position on the wall to mount the
speaker and the bracket so that no one will injure his/
her head or face with the edge of the bracket.
5
E-