Mounting The Rear Speakers (And Rear Center Speaker For Ns-P236) - Yamaha NS-P236 Bedienungsanleitung

Mounting the rear speakers (and rear center speaker for
NS-P236)
1
Tapping screw
(Available at the
hardware store)
Diam. 3.5 to 4 mm
70 mm 70 mm
10 mm
Min.
20 mm
2
70 mm
Using the Yamaha Speaker Stand SPS-80 (option)
By using the Yamaha Speaker
Stand SPS-80, speakers can be
placed on the floor.
SPS-80
* The SPS-80 is not available in some areas.
Mount the rear speakers (and rear center speaker for NS-
P236) on a shelf, rack or directly on the floor, or hang them
on the wall.
To mount the speakers on a wall by
using the holes on the speakers' back
panels
1
Fasten screws into a firm wall or wall support as shown
in the figure.
2
Hang the speaker by mounting the holes on the
protruding screws.
* Make sure that the screws are securely affixed by the
narrow parts of the holes.
WARNING
● Each speaker weighs 0.9 kg (2 lbs.). Do not mount
them on thin plywood or a wall composed of a soft
surface material. If mounted, the screws may pull out
of the flimsy surface and the speakers may fall. This
may damage the speakers or cause personal injury.
● Do not affix the speakers to a wall using nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause the speakers to
fall.
● To avoid accidents resulting from tripping over loose
speaker cables, fix the cables to the wall.
● Select an appropriate position on the wall to mount
the speaker so that no one will injure his/her head or
face.
Holes
5
E-