Cleaning And Storing; Disposal; Packaging; Troubleshooting - Silvercrest SSB 36 B2 Bedienungsanleitung

BB58B6RXQGEDUB%ERRN 6HLWH  )UHLWDJ  $SULO    

7. Cleaning and storing

DANGER! Risk of electric shock!
~ Pull the power unit|11 out of the wall socket before
you clean the device. Make sure that no liquid gets
into the device.
• Clean the device with a slightly damp cloth. In case of
persistent contamination, you can also use a slightly
more gentle cleaner such as detergent. Solvents, spir-
its, thinners etc. must not be used, as they can damage
the surface of the device.
• When not using the device, store it in a place where
neither high temperatures nor moisture can affect it.
Remove the battery from the remote control.

8. Disposal

This product is subject to the provisions of Eu-
ropean Directive 2012/19/EC. The symbol
showing a wheelie bin crossed through indi-
cates that the product requires separate re-
fuse collection in the European Union. This
applies to the product and all accessories marked with this
symbol. Products identified with this symbol may not be dis-
carded with normal household waste, but must be taken to
a collection point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the consumption of raw
materials and protect the environment.
Batteries must not be discarded with your
household waste. Spent batteries must be dis-
posed of properly. Special containers are
available for this purpose in shops selling
batteries and at municipal collection points.
(Rechargeable) batteries marked with the following letters
contain harmful substances such as: Cd (cadmium), Hg
(mercury), Pb|(lead).

Packaging

When disposing of the packaging, make sure you comply
with the environmental regulations applicable in your
country.
38 GB

9. Troubleshooting

If your soundbar fails to function as required, please try this
checklist first. Perhaps there is only a minor problem, and
you can solve it yourself.
DANGER! Risk of electric shock!
Do not attempt to repair the device yourself under
any circumstances.
Fault Possible causes / Action
• Has the device been connected to
the power supply? Is the LED|1 lit
up?
• In the case of a connection to the
HDMI ARC|8 socket, the HDMI ca-
ble as well as the connected device
(e.g. a television set) must also be
ARC-enabled. If your television set is
not provided with an ARC-enabled
No function
HDMI connection, switch to a differ-
ent type of connection or replace the
television set.
• Replace the old HDMI cable with a
new, ARC-enabled cable.
• Has the correct audio signal been se-
lected at the audio device (e.g. tele-
vision set)? Select PCM 2.0 (or PCM
stereo) as the audio output.
• Is the Bluetooth function of the audio
device active?
• Did you switch off the device?
No Bluetooth • Does a Bluetooth connection to an-
connection other device exist? Press the
ton|15 or the button PAIR|5 until the
blue LED starts flashing and establish
the new connection.
• Is the volume set too low on the au-
dio device?
No music play- • Have you selected the correct con-
back nection?
• Is the volume too low or switched
off?
• In the case of any possibly occurring
interferences, remove, if necessary,
Interferences
any mobile phones, tablets or other
during opera-
devices with radio wave operation
tion
located in the vicinity of the sound-
bar.
but-