Remote Control - Yamaha TSX-112 Bedienungsanleitung

iPod
Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the
connection to your iPod (☞ P. 6).
Status message
iPod Connecting
iPod Charging
Unknown iPod
iPod
iPod Unplugged
Over Current
Problem
No sound
The iPod does not charge up.
Suddenly the music being
played back is canceled and
another track starts playing
without performing any
operation.

Remote control

Problem
The remote control does not
work properly.
Cause
This unit is in the middle of recognizing
the connection with your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
This unit has recognized your iPod;
however, it cannot obtain information
such as elapsed time.
Your iPod was removed from the iPod dock. Station your iPod back in the iPod dock (☞ P. 6).
The iPod being used is not supported by
this unit.
The iPod is connected at an angle.
Cause
The iPod is not set in the iPod dock
firmly.
Headphones are connected.
The iPod software version has not been
updated.
The iPod is set in the iPod dock
improperly.
The system is set to power save mode
(☞ P. 2).
The iPod's Shake to Shuffle function is
turned on.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor
of the unit and the remote control.
TROUBLESHOOTING
Remedy
If the message continues to appear in the
front panel display and playback does not
start, connect the iPod again (☞ P. 6).
Connect the iPod again (☞ P. 6).
Only iPod classic, iPod nano (2nd
generation and later), iPod touch and iPhone
are supported.
Disconnect the iPod and then turn the
system off and on again. Then connect
supported iPod again (☞ P. 18).
Solution
Set the iPod firmly.
Remove the headphones.
Download the latest iTunes software to
update the iPod software version to the
latest.
Remove the iPod from the unit, and then set
it in the iPod dock again (☞ P. 6).
Set CLOCK to ON on the rear panel to
cancel power save mode (☞ P. 4).
Turn off the Shake to Shuffle function in
the iPod's settings.
Solution
For information on the remote control
operation range, refer to "Using the remote
control" (☞ P. 5).
Change the lighting or orientation of the
unit.
Replace the battery with a new one.
Remove the obstacles.
15
En