Novamatic Fust WA 914 E Benutzerhandbuch Seite 13

13
Starting a programme without
the Ende in/Fini dans option
Touch the button
• The indicator of the button
to flash and stays on.
• The programme starts, the door
locks, the indicator
• The drain pump can operate for a
short time at the beginning of the
washing cycle.
After approximately 15 minutes
from the start of the
programme:
• The appliance adjusts
automatically the programme
duration agree with the
laundry load.
• The display shows the new
value.
Starting a programme with the
Ende in/Fini dans option
1. Touch the button
choose the number of hours in which
you want the washing cycle to be
finished.
The display shows the number of hours you
set (e.g. ) and the indicator above the
button is on to show that his option is
active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed,
the programme starts automatically.
You can cancel or change the
set of the Ende in/Fini dans
option before you touch the
button
button
the Ende in/Fini dans option.
To cancel the the Ende in/Fini dans option:
.
is on.
again and again to
:
. After touching the
you can only cancel
a. Touch the button
appliance to pause. The indicator of
button
b. Touch the button
stops
indicator above this button goes off.
Touch the button
the programme immediately.
Interrupting a programme and
changing the options
You can change only some options before
they operate.
1. Touch
The indicator of this button flashes.
2. Change the options. If you change any
option the Ende in/Fini dans option (if
set) will be disabled.
3. Touch
The programme continues.
Cancelling a programme
1. Press the button
to cancel the programme and to
deactivate the appliance.
2. Press the same button again to activate
the appliance. Now, you can set a new
washing programme.
Before starting the new
programme the appliance could
drain the water. In this case,
make sure that the detergent is
still in the detergent
compartment, if not fill the
detergent again.
Opening the door
While a programme (or the
the appliance door is locked. The indicator
is on.
CAUTION! If the temperature
and level of the water in the
drum are too high, you cannot
open the door.
to set the
flashes.
until the
again to start
.
again.
for some seconds
) operates,