Child-Proof Lock; Ending The Program Through Canceling - Beko WMD 66160 Handbuch

door can be opened if the water level is suitable.
Laundry may be added / taken out by opening
the door.
Door lock
The loading door can not be opened yet due to
safety reasons while the "Ready" lamp is flashing.
The loading door can be opened once the
"Ready" lamp starts lighting up continuously.

Child-proof lock

You can protect the appliance from being
tampered by children by means of the child-proof
lock. In this case, no change can be made in the
running program.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions for 3
sec. "C on" (Child lock is activated) label appears
on the screen. The same symbol will also be
displayed whenever any button is pressed while
the machine is child-locked.
Child-proof lock lamp on the program follow-up
indicator will light up when the child-proof lock is
activated.
To deactivate the child-proof lock, press the 1st
and 2nd auxiliary function buttons for 3 sec. "C
OFF" (Child-proof lock is deactivated) symbol
appears on the screen. Child-proof lock lamp on
the program follow-up indicator will go off when
the child-proof lock is deactivated.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program. "Ready" warning
lamp flashes during canceling and "End" will
appear on the display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed
from the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must
be cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also at
the end of each water intake hose where they are
connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as
they get dirty.
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with an
appropriate brush.
• If the filters are very dirty, you can pull
them out by means of pliers and clean
them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
9 - EN