Child-Proof Lock; Ending The Program Through Canceling - Beko wmd 26125 t Handbuch

"Cottons 40" program instead of "Cottons 60"
program. Select the "Cottons 40" program.
Start the program.
Switching the machine to standby
mode
Press "Start/Pause/Cancel" button
momentarily to switch your machine to the
standby mode. Auxiliary functions can be
cancelled or selected in accordance with
the step the program is at. The door can be
opened if the water level is suitable. Laundry
may be added / taken out by opening the
door.

Child-proof lock

This function protects the appliance from
being tampered by children. In this case, all of
the buttons are inactive except On/Off button;
by On/Off button you can whether stop or
resume (while child-lock on) the program of
your machine.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions
from the left for 3 sec. Child-proof lock lamp
on the program follow-up indicator will light
up when the child-proof lock is activated.
To deactivate the child-proof lock, press the
same buttons for 3 sec.
Ending the program through
canceling
In order to cancel the selected program,
press the "Start/Pause/Cancel" button for
3 seconds. You can select and start a new
program when the "Ready" light is lit.
The "Spin" light illuminates if the cancellation
process is activated in the middle of the
program and the machine can either drain all
the water or can take in water 3 times at most
to cool down the clothes and perform the
draining process.
The program which is selected first will keep
on going even if the position of the program
selection button is changed. A new program
can be selected or started after "Program is
cancelled" in order to change the washing
program.
End of program
The "Ready" lamp on the program follow-up
indicator will light up when the program comes
to an end. The door can be opened and the
machine is ready for a second cycle now.
Press the "On/Off" button to shut down the
machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
9 - EN