Child-Proof Lock - Beko WMD 57122 Handbuch

Progress of program
Progress of a running program is shown through
the program follow-up indicator. At the beginning
of every program step, the relevant indicator
lamp will light up. The indicator that is lit up at the
bottom of the series of symbols indicates the step
that is being carried out.
C
If the machine is not spinning, the
program may be in rinse hold mode or the
automatic spin correction system has been
activated due to an excessive unbalanced
distribution of laundry in the machine.
Changing the selections after the
program has started
Turning the program knob while the program is in
a normal flow will not change the program.
Switching the machine to standby mode
Press "Start/Pause/Cancel" button momentarily
to switch your machine to the standby mode.
"Pause" lamp (II) will light up to indicate that the
machine is switched to standby mode.
Selecting or canceling an auxiliary function in
standby mode
Auxiliary functions can be cancelled or selected in
accordance with the step the program is at.
Adding/removing laundry in standby mode
The door can be opened if the water level is
suitable. Laundry may be added / taken out by
opening the door.

Child-proof lock

You can protect your machine from being
tampered by children by means of the child-proof
lock. In this case, no change can be made in the
running program.
The machine is switched to child-lock by pressing
the 2nd and 4th auxiliary functions from top for 3
sec. "CL" (Child lock is activated) label appears
on the screen. The same symbol will also be
displayed whenever any button is pressed while
the machine is child-locked.
Lamp of the first auxiliary function from the top will
flash when the child-proof lock is activated.
To deactivate the child-proof lock, press the 2nd
and 4th auxiliary function buttons for 3 sec. "CL"
(Child-proof lock is deactivated) label appears on
the screen. Lamp of the auxiliary function will fade
if it is not selected when the child-proof lock is
deactivated.
Ending the program through canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also at
the end of each water intake hose where they are
connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as
they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
Draining any remaining water and
45 - EN