EBECO EB-Therm 205 Handbuch Seite 40

Ventilation mode
If the room temperature falls by more
than 3°C in a single minute, e.g. when
airing the room, the ventilation mode is
activated. The thermostat will then stop
heating for 15 minutes before returning
to normal mode. This function is always
active.
Delay between turning off and on
There is a built-in delay in order to
avoid unnecessary wear and tear on
internal components and to extend
the life of the thermostat. If you raise
the desired temperature so that the
thermostat comes on, and then lower
it shortly afterwards, it takes four min-
utes before it goes off again.
Current status
The heat symbol allows you to see the
current status. See the Symbols on the
display section.
Symbol on - the thermostat is on and
the underfloor heating is activated.
Symbol off - the thermostat is on and
the underfloor heating is switched off.
Control functions
The thermostat can regulate the tempera-
ture in three different ways. This enables
the comfort temperature and any flooring
temperature requirements to be combined.
38