Machine Settings - Electrolux edh 97980 w Benutzerhandbuch

Machine settings

Setting
Buzzer permanent
on/off
1)
Water hardness
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according
to geographical locations thus varying its conductivity values. Relevant variations of the conductivity
of the water compared to those prefixed by the factory could slightly influence the residual humidity
of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying
sensor based on conductivity values of the water.
The alarm is by default always off. To set permanent alarm on (off):
1. Turn the programme selector to any programme.
2. Press simultaneously the Séchage (Dryness) and Anti-froissage (Long
Anti-crease) buttons and hold down for approx. 5 seconds.
1. Turn the programme selector to any programme.
2. Press simultaneously the Anti-froissage (Long Anti-crease) and Départ/
Pause (Start/Pause) buttons and hold down for approx. 5 seconds.
3. Press the Départ/Pause (Start/Pause) button until you set desired level:
- low conductivity <300 μS/cm
- medium conductivity 300-600 μS/cm
- high conductivity >600 μS/cm
4. To memorize setting press simultaneously the Anti-froissage (Long Anti-
crease) and Départ/Pause (Start/Pause) buttons or turn knob to
position
Implementation
electrolux 59
off