50 electrolux
Setting
1)
Water hardness
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of
the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the
water.
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Droogtegraad) and Start/Pause but-
tons and hold down for approx. 5 seconds.
3. Press the Start/Pause button until you set desired level:
- the LED on - low conductivity <300 μS/cm
- the LED on - medium conductivity 300-600 μS/cm
- the LED on - high conductivity >600 μS/cm
4. To memorize setting press simultaneously the Dryness (Droogtegraad)
and Start/Pause buttons or turn knob to
Implementation
off position