Preparing The Load; Clothes Preparation; Do Not Tumble Dry; Energy Saving - Candy EVOH 981NA1T Grand Evo Anleitung

Before using the tumble dryer for the first time:
Please read this instruction book thoroughly.
Remove all items packed inside drum.
Wipe the inside of the drum and door with a
damp cloth to remove any dust which may
have settled in transit.

Clothes Preparation

Make sure that the laundry you are going to dry
is suitable for drying in a tumble dryer, as shown
by the care symbols on each item.
Check that all fastenings are closed and that
pockets are empty. Turn the articles inside out.
Place clothes loosely in the drum to make sure
that they don't get tangled.

Do Not Tumble Dry:

Woollens, silk, delicate fabrics, nylon stockings,
delicate embroidery, fabrics with metallic dec-
orations, garments with PVC or leather
trimmings, training shoes, bulky items such as
sleeping bags, etc.
IMPORTANT: Do not dry articles which
have been treated with a dry cleaning fluid or
rubber clothes (danger of fire or explosion).
During the last 15 minutes (roughly) the
load is always tumbled in cool air

Energy Saving

Only put into the tumble dryer laundry which
has been thoroughly wrung or spin-dried. The
drier the laundry the shorter the drying time thus
saving electricity.
ALWAYS
Try to dry the maximum weight of laundry, this
will save time and electricity.
Check that the filter is clean before every
drying cycle.
NEVER
Exceed the maximum weight, this will waste
time and electricity.
Put dripping wet items into the tumble dryer,
this may damage the appliance.

PREPARING THE LOAD

Maximum Drying Weight
Cottons Max. 8 kg
Synthetics Max. 4 kg
Do not overload the drum, large items when
wet can exceed the maximum admissible clothes
load (for example: sleeping bags, duvets).
Sort the Load as Follows
By care symbols
Suitable for tumble drying.
. .
Tumble drying at high temperature.
.
Tumble drying at low temperature only.
Do not tumble dry.
By amount and thickness
By type of fabric
Cottons/linen:
Synthetics: Blouses, shirts, overalls, etc. made
of polyester or polyamid, as well as for cot-
ton/synthetic mixes.
By drying level
Do not install the product in a room where
there is a risk of frost occurring. At temperature
around freezing point the product may not be
able to operate properly: there is a risk of
damage if the water is allowed to freeze in the
hydraulic circuit (valves, hoses, pumps).
For a better product performance the ambient
room temperature must be between +2°C and
+35°C.
EN 7