Before You Call An Engineer - Philips DVDR 730/02 ShowView Bedienungsanleitung

Pan & scan-konvertierung, letterbox-konvertierung, kindersicherheit, progressive scan

Inhaltsverzeichnis

Verfügbare Sprachen

PROBLEM

Your recorder does

not respond to any

button being pressed

and the display shows

'PHILIPS', 'IS TV ON?':

The device does not

react when you press a

button, although the

remote control works:

Your DVD recorder

does not respond to

any button being

pressed:

Resetting the machine

to the default factory

settings

Remote control does

not work:

Data transfer from TV

set via 'EASYLINK'

does not work:

If you have any problems using this DVD recorder, the reason may be one of the following. You can

also call the customer service centre in your country.

The telephone numbers can be found on the back of this instruction manual.

You can also visit our web page 'http://www.p4c.philips.com' .

Have the model number (MODEL NO) and the production number (PROD.NO) of your recorder

ready.

The production number (PROD. NO.) is printed on the type plate at the back or on the bottom

SOLUTION

Recorder in initial installation mode: Switch on the TV, switch over to the DVD recorder socket.

Now the menu for language selection should appear. Please read paragraph 'Initial Installation' in the chapter

'Installing your DVD Recorder'.

'Key lock' is switched on: All buttons on the front of the set are locked.

Switch off the function:

Pull out the mains plug from the wall outlet.

Press and hold down h and OPEN/CLOSE J and put back the mains plug into the wall

outlet.

As soon as the time or '--:--' appears in the display (ca. 6 - 10 seconds), release h and

OPEN/CLOSE J .

There is no power supply: check the power supply

A programmed recording (Timer) is currently being made: If desired, cancel the programmed recording

(Timer) with STANDBY m .

There is a technical problem: disconnect from the mains power supply for 30 seconds, then connect again.

If this doesn't help, you can reset your DVD recorder to the default factory settings.

Important:

All the information stored (TV channels, time and date, TIMER) will be lost.

Disconnect from the mains power supply.

Press and hold down the STANDBY-ON m button on the device and reconnect to the

mains power supply.

Release the STANDBY-ON m button when the features appears on the display. All the

information stored (TV channels, time and date, TIMER) will be lost.

Please read paragraph 'Initial Installation' in the chapter 'Installing your DVD Recorder'.

Remote control not pointed toward the DVD recorder: Point the remote control at the machine. See if the

'o(((' appears on the display briefly each time you press a remote control button. If it does, the Recorder is

receiving information from the remote correctly.

There is a technical problem: Take out the batteries, wait for 10 seconds and put them in again.

Batteries are flat: Change the batteries.

Data transfer is controlled via pin nr. 10 of the scart cable. It is possible that the connection to this pin is

interrupted or that the signal is distorted by an additional device connected to the EXT2 AUX-I/O socket.

Remove any scart switch boxes, mixing consoles, signal amplifiers, ... connected between the DVD recorder

and the TV set. Connect the DVD recorder directly to the TV set.

Remove any additional devices from the EXT2 AUX-I/O socket.

Try using another scart cable (all pins wired).

Please observe the installation order:

1) Switch on the TV set

2) Connect the DVD recorder to the mains

3) Switch on the DVD recorder using STANDBY m

4) The data transfer should now work.