Problem solving for programmed
recordings
PROBLEM
The DVD recorder is
not responding
'Switch off, timer
recording' flashes on
the TV screen.
Error message: 'Insert
recordable disc'
The error message
'Disc locked' appears
briefly on the screen.
Error message:
'Memory full'
The 'Data error'
message appears on
the screen.
The 'Collision'
message appears on
the screen.
Programming a recording (TIMER)
SOLUTION
b
While a programmed recording is being made, you cannot operate your DVD recorder manually. If you want
to cancel the programmed recording, press STANDBY m .
b
The DVD recorder was switched on a few minutes before the start of a programmed recording.
Switch off the DVD recorder using STANDBY m . A programmed recording (timer) will only function if the
DVD recorder is switched off ( STANDBY m button).
b
Either a disc has not been inserted or the disc cannot be used for recording. Insert a disc on which recordings
can be made.
Search the position on the disc where you want the recording to begin.
Switch off the DVD recorder using STANDBY m .
b
A write-protected disc has been inserted. Undo the write protection (see 'Preventing accidental erasing of
discs' in 'Manual recording') or insert a different disc.
b
If this error message appears after pressing TIMER s , then all TIMER blocks are already programmed.
No more recordings can be programmed. Press the C button. If you want to clear or check a programmed
recording (TIMER block), select it with A or B .
b
The data for the recording could not be transferred. Please check date, start time and finish time of the
programmed recording.
b
Two programmed recordings overlap.
b
If you ignore this error message the show with the earlier start time will be recorded first. The start of the
second show will not be recorded.
b
Change the setting for either of the two recordings.
b
Clear either of the two recordings
59