Cursor; Loading And Re-Loading The Tool - Avdel 07535 MkII Betriebsanleitung

P u t t i n g i n t o S e r v i c e
C u r s o r
While the cursor will be fitted the correct way round when the tool is supplied, we recommend that you check its orientation before
fitting the nose equipment. The sprung loaded, slightly concave, end of the cursor should point towards the front of the tool as shown
in the illustration.
When fitted the correct way round, the cursor will easily slide out of the barrel when a mandrel is pushed into its centre then pulled
back.
To reverse the orientation of the cursor, follow these steps:
Item numbers in bold refer to the general assembly and parts list
for the 07535-02500 MkII type on pages 26-27.
•
Remove the Clip 46 and slide off End Cap 38.
•
Using an Allen Key, remove one cap head screw 43 ensuring
that any trapped air is exhausted. Remove the second Cap
Head Screw 43.
•
Pull out Rear Plug 45.
•
Pull out Tail Jaw Piston Assembly 14 together with Jaws 9.
•
Lift out Spring 13 and Jaw Housing 8.
•
Insert a mandrel into the hole in the rear end of Barrel 25 until it protrudes through the front of the barrel, then pull out the mandrel
and cursor together through the front.
•
Reassemble components in reverse order.
•
Insert Mechanical Cursor Assembly 5 into the front of the barrel, correct way round.
L o a d i n g a n d R e l o a d i n g t h e To o l
The procedure for loading the tool and for fitting the nose equipment to the tool is integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the fastener to be
placed.
To identify nose equipment components or to select the correct elements, read the nose equipment section, on pages 12-21.
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fitting the nose
equipment
as shown overleaf.
Item numbers in bold refer to the general assembly and parts list for the 07535-02500 MkII type on pages 26-27.
If fitted incorrectly, the cursor will not allow feeding of the fasteners.
IMPORTANT
SPRING
LOADED END
IMPORTANT

CURSOR

TOOL
BARREL
NOSE
JAWS
9