Thomas INOX 1520 Plus Gebrauchsanweisung Seite 9

Assembly Instructions
Dear client,
thank you very much for your confidence.
You have made the really good choice:
The Thomas Wet & Dry Vacuum-Cleaners are
always usable for optimal cleaning task in your
private workshop, cellar and garage.
The Wet & Dry models INOX 1420 plus/1520 plus
and INOX 1520 S are delivered with a 20-liter
stainless-steel dirt collecting bin, and enhanced
motor casing with protection against splash water.
If this appliance brings you entire satisfaction, we
would be grateful to you to recommend us. We
prefer this sort of promotion to a big luxurious
advertising campaign.
Assembly Instructions
A + B Assembling the chassis
Place the chassis ring upside down on a
stable surface.
Drive the shafts by the ribbed end into the
bore marked with the number 4 on the chassis
ring.
Then push the wheels in as far as they will
go. Turn the collecting bin upside down (i.e.
opening facing the floor).
Place the chassis ring on the collecting bin in
such a manner that one of the castor wheels
stand directly in line with the suction socket.
Then press the chassis ring firmly until it snaps
into place.
C Fitting the motor block
Place the motor block onto the collecting bin,
making sure that the operating switch lies
directly in line with the middle of the suction
socket.Lastly, secure the motor block by means
of both snap fasteners.
D Connecting the flexible hose
Connecting the flexible hose. Remove the
hose by turning the hose connecting piece
and withdrawing the hose.
Assemble the accessoires you require.
Connect the main cable.
Operating the appliance
The MultiVac is switched on and off by means
of the switch located on the motor block
casing.
The mains supply voltage must correspond to
the voltage given on the rating plate.
E Changing the cartridge filter
(Optional extra, Part no. 787021/421)
Pull out the plug!
Depending on the model type, the retaining
clips are either already pre-mounted or must
be fitted according to the enclosed Assembly
Instructions F.
Undo the snap fasteners, remove the motor
block from the collecting bin and turn over.
Secure the cartridge filter by the pre-mounted
retaining clips.
Place the new cartridge filter in an upright
position on the motor flange and gently but
firmly slide it into place on the filter mounting.
The pre-mounted retaining clips automatically
snap into place, thus securing the cartridge
filter. Place the motor block on the collecting
bin again and secure by means of the snap
fasteners.
F Inserting the paper filter bag
(when changing the paper filter bag)
Place the filter bag inside the collecting bin,
making sure that the opening located in the
cardboard inlay is placed in line with the
suction soket.
Then press the filter bag evenly
around the sides of the collecting bin.
Thomas paper filter bags are essential
when vacuuming fine dust, e.g. soot, ashes,
sawdust or cement. However, they are also
recommended for normal use, as they not
only improve the retention of dust, but also
make filter changes more hygienic.
Changing the cartridge filter
Gently pull the retaining clips back in the
direction indicated and carefully remove the
cartridge filter in an upright position from the
filter mounting. Clean the soiled cartridge
filter under running water – if necessary, with
a brush.
Drain and allow to dry thoroughly before
using again.
9