Operation Procedures; Maintenance - CombiSteel VDB 26 – 7476.0150 Gebrauchsanweisung

OPERATION PROCEDURES

1.Unpack the ice maker from its carton, then remove the ice shovel, inlet/outlet tubes, and sealing
washers, from the container in the icemaker where they are packed for transit.
2.Position the ice maker on a well ventilated place, leaving at least a 150mm gap between the ice
maker and the walls/ceiling etc. The icemaker must be level, and situated away from any heat source.
3.Attach one end of the φ12mm flexible plastic corrugated pipe to the water outlet on back of
machine. The other end of the pipe should be inserted into a plumbed in stand waste pipe, or a
suitable container for the collection of the waste water.
4.connect the 3/4" water inlet hose, supplied with the ice maker, to a drinking water supply and then
connect the other end to the water inlet on the back of the machine. When connecting this hose, use
the sealing washers supplied with the ice maker to eliminate the risk of a water leak. The water
pressure must be a minimum of 1Kg/cm2 or 14.7psi and a maximum of 8 kg/cm2 or 117psi.
5.Plug the power lead in to the supply socket, then press the green on/off switch on the ice maker to
start it, the green "run" light will be lit. The ice maker will start to operate.
6.The operation of the ice maker is completely automatic unit the ice is removed from the container.
Water supply-ice making-ice transfer-ice storage.
7.If the storage container is full with ice, the "ice full" indicator on the display panel will light, and the
ice maker will stop automatically. Remove the ice from the storage container, wait for five minutes,
then restart the ice maker.
8.Should the water supply be restricted or fail, the "water low" light will be lit. The ice maker will stop
automatically. When the water supply is restored, wait for at least five minutes then re-start the ice
maker.

MAINTENANCE

1.If the compressor stops for any reasons like water shortage, too much ice, power off, etc., Don't
restart it right away. You can restart it 5 minutes later to protect compressor.
2.Check regularly the connectors of the water inlet and outlet tubes and drain the little surplus water
that may occur.
3.If the ice maker will be unused for long periods of time, please screw off the plastic drainage
connector screw on the back of the ice maker so as to drain the surplus water in the water groove.
Then screw it on. Wipe the inner liner of the ice storage container with a clean rag.
4.When plugging or unplugging, the plug should be held by
hand and the wires should not be dragged heavily.
5.Please clean the ice maker and its water supply system for
one time every month. The ice maker should be unplugged
before cleaning.
6