Cleaning And Maintenance - Samsung SR8730 Benutzerhandbuch

Vacuum cleaning Robot may not be able to continue its
operation if it is stuck at the entrance or veranda doorsill.
NOTE
- Vacuum cleaning Robot stops operating for safety reasons if it
cannot move for more than 5 minutes.
- To resume operating, turn the Power Switch off and then on again
after moving it to a location where it can continue cleaning.
Vacuum cleaning Robot cannot completely clean locations
that it cannot reach, such as corners, and spaces between
NOTE
sofas and walls.
- Please clean these locations occasionally.
Dust clusters may remain after cleaning, when the vacuum cleaning robot fails to
pick up dust clusters that were formed while cleaning.
NOTE
- In this case, sweep up the dust with another cleaning tool.

CLEANING AND MAINTENANCE

When cleaning the product, do not spray water directly onto
the exterior or wipe it with a volatile material such as benzene,
CAUTION
thinner or alcohol.
- This may result in critical damage to the product.
Do not forcefully press the bumper on the Vacuum cleaning
Robot.
CAUTION
- If the bumper sensor gets damaged, the Vacuum cleaning Robot
may bump into walls or furniture.
The unit must not be disassembled or reconstructed by anyone
other than a qualifi ed service engineer.
CAUTION
- This may result in damage to the product.
Remove any foreign substances accumulated on the Obstacle
and Cliff sensors on a regular basis.
WARNING
- Dirt accumulated on the sensors will result in inaccurate
functioning of the sensors.
Cliff sensor Cliff sensor
Obstacle sensor Obstacle sensor
safety information _11