Koenic KVC 710 Gebrauchsanleitung Seite 17

Cleaning and care
Warning!
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Never immerse any electrical parts of the
product in water or in other liquids during
cleaning. Never place it under running
water.
Emptying the dust canister
If the suction power diminishes, the dust
15
canister must be emptied and the filters
must be cleaned. We recommend to empty
the dust canister outside of the house.
a) Remove the suction hose from the dust
canister. Press the unlocking device and
remove the filter by bringing it forward.
b) To empty the dust canister, simply press
the release on the bottom so that the
bottom of the canister opens and the
dust falls out. Hold the dust canister
over a rubbish container whilst you are
emptying it.
c) Loosen the filter lid and remove the entire
filter insert from the dust canister. Empty
the remain dusty from the dust canister.
d) Re-assemble all of the components that
have previously been removed. Assembly
is carried out in reverse order.
Cleaning the main filter
a) Loosen the filter lid and remove the entire
16
filter insert from the dust canister. Break
down the filter into all of its individual
parts. Tap the filter to remove the dust
and clean all parts with water and dry
them thoroughly.
b) Re-assemble all of the components that
have previously been removed. Assembly
is carried out in reverse order.
IM_ KVC710_150429_V10_HR.indb 17
Cleaning the motor filter
Remove the motor filter and tap it
17
to remove the dust. Then re-insert it.
Reassemble all of the components that
have previously been removed. Assembly is
carried out in reverse order.
Warning!
Never use the vacuum cleaner without a
motor filter, as otherwise, the motor will soon
get dirty and will be subject to wear. If the
motor filter gets dirty, the suction power will
diminish.
Cleaning the exhaust air filter
Open the flap, take the filter out and tap it
18
to remove the dust. Assembly is carried out
in reverse order. Insert the filter in the right
direction so that the correct side is facing
the motor.
Technical data
Rated Voltage : 220 - 240 V~, 50/60 Hz
Rated input power : 700 W
Protection class : II
• This is a general purpose vacuum cleaner
• The Erp test method is according to (EU)
No 666/2013, (EU) No 665/2013 & EN
60312:2013
• Please refer to below website for detail
technical information, or contact us for
technical document:
www.koenic-online.com
English
17
29/4/15 11:56 AM